serial: 8250_pnp: Remove unneeded ->iotype assignment

If ->iobase is set the default will be UPIO_PORT for ->iotype after
the uart_read_and_validate_port_properties() call. Hence no need
to assign that explicitly. Otherwise it will be UPIO_MEM.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20250124161530.398361-7-andriy.shevchenko@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Author: andy-shev

drivers/tty/serial/8250/8250_pnp.c

@@ -436,7 +436,6 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
 {
 	struct uart_8250_port uart, *port;
 	int ret, flags = dev_id->driver_data;
-	unsigned char iotype;
 	long line;
 
 	if (flags & UNKNOWN_DEV) {
@@ -448,14 +447,11 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
 	memset(&uart, 0, sizeof(uart));
 	if ((flags & CIR_PORT) && pnp_port_valid(dev, 2)) {
 		uart.port.iobase = pnp_port_start(dev, 2);
-		iotype = UPIO_PORT;
 	} else if (pnp_port_valid(dev, 0)) {
 		uart.port.iobase = pnp_port_start(dev, 0);
-		iotype = UPIO_PORT;
 	} else if (pnp_mem_valid(dev, 0)) {
 		uart.port.mapbase = pnp_mem_start(dev, 0);
 		uart.port.mapsize = pnp_mem_len(dev, 0);
-		iotype = UPIO_MEM;
 		uart.port.flags = UPF_IOREMAP;
 	} else
 		return -ENODEV;
@@ -471,12 +467,6 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
 	if (ret)
 		return ret;
 
-	/*
-	 * The previous call may not set iotype correctly when reg-io-width
-	 * property is absent and it doesn't support IO port resource.
-	 */
-	uart.port.iotype = iotype;
-
 	if (flags & CIR_PORT) {
 		uart.port.flags |= UPF_FIXED_PORT | UPF_FIXED_TYPE;
 		uart.port.type = PORT_8250_CIR;