End point of Circle with radians doesn't return to the circles center. (QB compatibility issue)

[CMR779]

If you run this in QB4.5 the end point will be the circle's center. I'm pretty sure this is the expected outcome of all QB's circle drawing processes. "The last point CIRCLE references, after drawing, is the center of the ellipse or circle."

`
Screen 12
Cls

Color 4

Circle (320, 240), 50, 4, -5, -2
Color 10
Line Step (0,0)-(320,240)

Sleep
End

`

[ImortisInglorian]

Running your code, I don't see what the problem is. It appears to be functioning as you describe it should. Perhaps a few screenshots of what you are seeing and what should be seen would help.

[CMR779]

I changed the code a bit to give a better visual. Maybe it's just in the linux version that I'm using, but the origin of the green line is at the end of the arc instead of the center of the circle.

`
Screen 12
Cls

Color 4

Circle (320, 240), 50, 4, -5, -2
Color 10
Line Step (0,0)-(100,100)

Sleep
End
`

[CMR779]

The first image is the QB4.5 result. The second image is from freebasic on linux. Sorry, I was trying to be brief, but I guess I overdid it.

[rafageist]

In QuickBASIC (QB), when using CIRCLE with starting and ending angles, the current graphics cursor (PSET position) is reset to the center of the circle after drawing the arc.

In FreeBASIC, the CIRCLE statement leaves the cursor at the last point of the arc, which breaks compatibility with legacy QB code that expects LINE STEP and other relative commands to start from the center.